「秦皇岛快速门」快速卷帘门质量检测工作有哪些



What is the quality inspection work of "Qinhuangdao Express Gate" Fast Curtain Door


 

当您安装了一樘快速门后，在验收的过程中，不仅要对门的外观进行仔细的查看，很多内在性能够也要进行检测。


When you install a fast door, in the process of acceptance, not only the appearance of the door should be carefully examined, but also many inherent performance should be tested.


并且要多运行几次，如果条件允许，做好能够试运行几天，因为优质的快速门，是可以无障碍无间断运行的。


And to run several more times, if conditions permit, do a good job can test run for a few days, because high-quality fast doors, can be accessible and uninterrupted operation.

 

多次的运行和检测，能够判断是快速门的电机质量，是否存在散热效果差的情况，并且，在多次的运行过程，看是否有较大的噪音和震动。


Many times of operation and testing, can judge the quality of the motor of the fast door, whether there is a poor heat dissipation effect, and in many times of operation process, to see whether there is a greater noise and vibration.


「秦皇岛快速门」快速卷帘门质量检测工作有哪些


What is the quality inspection work of "Qinhuangdao Express Gate" Fast Curtain Door


1.在平时保养工业门时，您可以用高浓度家用洁净剂清，洗轨道，去除污垢和硬化的油脂。将转轴彻底清洗干净，然后将轨道和转轴擦干。


1. In the usual maintenance of industrial doors, you can use high-concentration household cleaner to clean, wash tracks, remove dirt and hardened grease. Clean the spindle thoroughly, then dry the track and the spindle.


2.您可以拿一个水平仪检查轨道，看轨道是否在同一水平线上，在墙壁上，两条轨道必须处于同一高度，安全的电动卷帘门轨道应当略向门体后部倾斜。


2. You can check the track with a level gauge to see if the track is on the same horizontal line. On the wall, the two tracks must be at the same height. The safe electric rolling shutter track should be inclined slightly to the rear of the door body.

 

3.请仔细观察安装工业门的所有部件，如果有松动的情况，一定要按照要求拧紧，在上掀门上，检查安装弹簧的平板，「唐山快速门」快速门运行时剧烈抖动的原因？，确保螺钉已经旋紧。


3. Please carefully observe all parts of the installation of industrial doors. If they are loose, they must be tightened as required. On the lifting door, check the spring-mounted plate. Why does the "Tangshan Express Gate" flutter violently when it is running? Make sure the screw is tightened.


4.检查工业门的弹簧，您可以调试它的弹力大小，弹力越大越好，「张家口快速门」互锁式堆积门调试注意事项 ，平时保养的时候还可以将经由门上方平板的缆线拉长，「北京快速卷帘门」生产快速门需要哪些设备？，然后在末端重新打结就可以了。


4. Check the spring of industrial door, you can adjust its elasticity. The greater the elasticity, the better. Notes for debugging the interlocking stacking door of Zhangjiakou Express Door. In peacetime maintenance, you can also stretch the cable through the flat above the door. What equipment is needed for the production of the fast door of Beijing Fast Rolling Curtain Door? Then tie the knot again at the end.


5.请检查将硬质快速门的各个部分固定在一起的铰链，将所有变松的螺钉拧紧，并更换受损的铰链。门有时向一侧下沉，这个问题往往可以通过维修铰链来纠正。


5. Please check the hinges that fasten the various parts of the hard fast door together, tighten all loose screws, and replace the damaged hinges. Sometimes the door sinks to one side. This problem can be corrected by repairing the hinges.